Skip to content
Back End | Tricks of the Trade
Back End / Tricks Of The Trade
13 July 2016

Cone of Silence

You have noticed that there is a perforated metal cone in the muffler of your new Husqvarna or KTM. You want to remove it as it is restrictive but it looks like it is welded in place.

Back End / Tricks Of The Trade
08 July 2016

Fitting a new chain - The Fast Way

This is such a simple trick that'll save all dirtbike riders a little bit of time and a lot of frustration.

Back End / Tricks Of The Trade
30 May 2016

Power Valve Adjustment

Two-stroke exhaust power valves provide loads of adjustment but the trick is knowing what to do.

Back End / Tricks Of The Trade
30 May 2016

How to make an emergency gasket

We show you how to make your own gasket quickly using a plain sheet of gasket paper, if time is an issue and you don't have time to source the correct one...

Back End / Tricks Of The Trade
25 November 2015

Power valve adjustment tricks of the trade

Two-stroke exhaust power valves provide loads of adjustment but the trick is knowing what to do

Back End / Tricks Of The Trade
10 November 2015

Fixing lose kickstarter levers Tricks of the trade

Kickstarter levers always come lose and often fall off, especially on two strokes, so here's a quick tip to avoid it becoming lose

Back End / Tricks Of The Trade
02 November 2015

Adjusting your headlight beam Tricks of the trade

If your headlight faces too high you won't see immediate dangers when riding at night. Here's our step-by-step guide on how to adjust your light beam

Back End / Tricks Of The Trade
29 August 2015

Camchain tensioner lock Tricks of the trade

Camchain tensioners can often be in hard-to-reach places that prevent you from easily reaching the tensioner and setting the tension correctly with a flat-blade screwdriver

Back End / Tricks Of The Trade
11 July 2015

Oiling your filter Tricks of the trade

ADB's technical editor, Mat Boyd runs through a few steps on how to correctly oil and fit your air filter

Back End / Tricks Of The Trade
01 May 2015

Removing a difficult broken bolt Tricks of the trade

Removing a broken bolt can be difficult but when you happen to snap an Ezy-out inside the bolt it becomes an even harder job to rectify the issue.

Back End / Tricks Of The Trade
29 January 2015

Emergency gasket Tricks of the trade

We show you how to make your own gasket quickly using a plain sheet of gasket paper, if you're in a hurry and don't have time to source the correct one.